[Latin Name] Allium sativum L.

[Plant Source] from China

[Appearance] Off-white to light yellow  Powder

Plant Part Used:Fruit

[Particle size] 80 Mesh

[Loss on drying] ≤5.0%

[Heavy Metal] ≤10PPM

[Storage] Store in cool & dry area, keep away from the direct light and heat.

[Shelf life] 24 Months

[Package] Packed in paper-drums and two plastic-bags inside.

[Net weight] 25kgs/drum

Main function:

1.Wide-spectrum antibiotic, bacteriostasis and sterilization.

2.Clearing away heat and toxic material, activating blood and dissolving stasis.

3.Lowering blood pressure and blood-fat

4.Protecting brain cell.Resisting tumor

5.Enhancing human immunity and delaying aging.

Applications:

1. Applied in pharmaceutical field, it is mainly used in treating eumycete and bacterial infection, gastroenteritis and Cardiovascular Disease.

2. Applied in health product field, it is usually made into capsule to lower blood pressure and blood-fat and delay senility.

3. Applied in food field, it is mainly used for natural flavour enhancer and widely used in biscuit, bread, meat products and etc.

4. Applied in feed additive field, it is mainly used in feed additive for developing the poultry, livestock and fishes against the disease and promoting growning and improving the flavor of egg and meat.

5. Applied in veterinary field, it is mainly used to inhibit the reproduction of colon bacillus, salmonella and etc. It also can treat respiratory infection and disease of digestive tract of poultry and livestock.

Stevia grows best in upland areas in sub-tropical climate. In other places it can be grown as an annual. The plant prefers a lightly textured, well-drained soil to which organic matter has been added. It needs ample water so that the soil is consistently moist, but not wet. In hot, sunny climates it will do best in semi-shade. Propagation is from seed sown in spring, but germination rates can be low-expect half the seeds sown not to germinate. Plant seedlings out once all danger of frost is over. Leaves are best harvested just before flowering. The plants will also grow from cuttings,which are best taken in late winter.The concentration of stevioside in the leaves of Stevia increasing when the plants are grown under long day condition.While, cultivating stevia on a large scale, it can be grown in well-drained red soil and sandy loam soil. The soil should be in the pH range of 6.5-7.5. Saline soils should be avoided to cultivate this plant.

Stevia can be successfully cultivated all around the year all over India expect theareas, which receive snowfall, or temperatures go below 5 degree Celsius in winter.The summer temperatures actually do not affect this plant if the high summer temperatures have already been factored in the cultivation practices.Since seed germination rate is very poor,it is propagated vegetative. Though stem cuttings are used for vegetative tissue culture plants have proven to be the best planting material for Stevia. Tissue culture plants of Stevia are genetically pure, free from pathogens and haveexcellent vigor. The tissue culture plants can be planted throughout the year,expect during peak summer. An ideal planting density is 40,000 plants per acre with spacing of 25×40 cm in a raised bed system. The soil can be enriched with abasal dressing of 25 tons of well rotten farmyard manure/hectare

Soil Type
Stevia requires very good drainage any soil that retain the moisture for very long period of time are unsuitable for Stevia cultivation and should be religiously avoided.Red soil and sandy loam with a 6-7 pH are best for the cultivation of Stevia.

Raised bed preparation
Forming raised beds is the most economical way to grow Stevia. The raised bed should be of 15 cm in height and 60 cm in width. The distance between each plant 23 cm. This would give a plant population of around 40,000 per acre.

Planting Material
There are basically two options for multiplication. The first is the tissue culture and second the stem cutting. Tissue culture is the best option but many farmers are tempted to try the stem cutting method for multiplication. As per practical experience, stem cutting is sometimes more expensive to produce than the tissue culture since the success rate of the stem cuttings establishment is very low, it takes minimum of 25 weeks for the stem cutting to develop in proper feeding roots for transplantation (younger stem cuttings transplants have shown more than 50% mortality in first few weeks of transplants in main field).

Harvesting
Another important aspect of harvesting is the timing of harvest. It should be noted that at no point of time plants should be allowed to flower since after flowering the Stevioside percentage goes down rapidly and leaves are rendered unmarketable. Leaves are harvested by plucking in a small quantity, or the entire plant with the side branches is cut leaving 10 to 15 cm from the base.The first harvesting can be done four to five months after planting. Subsequent harvesting can be done every three months, for five consecutive years. The sweetener in the leaf is maximum till the plant flowers. Just before flowering, the plant should be cut completely leaving 10 cm from the ground. The new flush of leaves will sprout from here. The new plant will be ready for harvest again in three months. The plant yields around 3000 kg of dried leaves from an acre of plantation every year. Harvesting should be done as late as possible, since cool autumn temperatures and shorter days tend to intensify the sweetness of the plants as they evolve into a reproductive state.

Unlocking the sweetness in your harvest
Once all leaves have been harvested it’s required to dry them. This can be
accomplished on a net. The drying process is not one that requires excessive heat;more important is good air circulation. On a moderately warm fall day, stevia crop can be quick dried in the full sun in about 12 hours. (Drying times longer than that will lower the stevioside content of the final product.)
Crushing the dried leaves is the final step in releasing stevia’s sweetening power. The
dried leaves are powdered, sieved and the fine powder is stored in containers. This can be done either by hand or, for greater effect, in a coffee grinder or in a special blender for herbs.

Web: https://www.natureherbs.org | www.natureherbs.co
Email : natureherbs@ymail.com
Watsapp: +91 841 888 5555
Skype: nature.herbs

In this video I show you how to make Easy Slime only in 2 Minutes! Ti,me is running and after 2 minutes is it possible to make a perfect slime quickly? I should be very hurried up during preperation and slime making. After that you will see how my slime is looking . You need just Clear glue, shaving foam and borax+water and food coloring !!! Elastic, non sticky Slime is super easy to make! You can easily apply the reciepe at home. Slime activator ( borax +water or lens solution or liquid starch or detergent liquid).You will see how easy slime making in 2 minutes ,the recipie is fantastic! This slime is made with Borax, but you could make it with liquid detergent or liquid starch if you wanted to make a slime without Borax. Borax solution : 1 glass of hot or warm water+ 1 teaspoonfull of Borax melted. I hope you like it; if it is please hit the like button and subscribe. Thanks!I
Slime was a toy product manufactured by pillo, sold in a plastic trash can and introduced in the winter of 1976. It consisted of a non-toxic viscous, squishy and oozy green or other color material made primarily from guar gum.[1] Different variations of Slime were released over the years, including Slime containing rubber insects, eyeballs, and worms and Masters of the Universe Slime for Hordak’s Slime Pit playset in the 1980s.
The late 1970s also introduced a Slime Monster board game; the object of the game was to avoid having your game piece slimed on by a foot-tall plastic monster that had slime oozing from its mouth. Other toy companies have produced their own slime such as the Ecto-Plazm play gel[2] sold with select figures in Kenner’s Real Ghostbusters toyline. Playmates’ Teenage Mutant Ninja Turtles figure line also had Retro-Mutagen slime sold in containers and included with playsets.
he main components are the polysaccharide guar gum and sodium tetraborate. As an alternative to the polysaccharide, other alcohol-group containing polymers (such as polyvinyl alcohol) may be used to a similar result. These non-polysacharide polymer products are more often referred to as flubber.
Polyvinyl acetate (Elmer’s glue), borax and water can also be used to approximate Slime’s characteristics.
Please join to my channel from link below;

https://www.youtube.com/channel/UCncW1mTN8mgKo4g9D8im-_A

HoppiTV :

https://www.youtube.com/channel/UCRzJw3ZtTiQJNAAGxzH-2dQ

FunnyKids TV :

https://www.youtube.com/channel/UClwXPc317YSIXbSxYREy5Lg

besides Easy Slime only in 2 Minutes , HAVE YOU SEEN MY PREVIOUS VIDEOS?!
How to make Slime Without Glue, Real Without Glue Slime, No Glue

DIY Rubber Band Slime , How to Make Crunchy Slime with Rubber Band, Most Satisfying Crunchy Slime

How to Make Black Fluffy Slime Without Glue, DIY Real No Glue Slime, Black Slime

Easy Basic Slime Tutorial, Three Ways !!! , How To Make Basic Slime For Beginners!!

How to Make Slime Without Glue, DIY Real No Glue Slime

How to make Giant Fuffy Slime with Dish Soap, without Shaving Cream, Easy to Make

How to make Crazy Jiggly Slime, Crazy Slime Recipe, Easy to Make https://www.youtube.com/watch?v=srSrXG20tQc
DIY Kinetic Sand Slime, How to make Slime with Kinetic Sand, Crazy Sand Slime

Live!! Fluffy Slime Video

How to Make Jiggly Slime, DIY Jiggly Slime, Super Easy to Make, No Glycerine Needed, No Borax

How to Make Fluffy Puffy Slime,Easy to Make Fluffy Pufyy Slime with Shaving Cream, Body Lotion