[Latin Name] Cinnamomun camphcra

[Plant Source] It is extracted from Ginkgo Biloba Leaf.

[Specifications]

1, Ginkgo Biloba Extract 24/6

Total Ginkgo flavone glycosides 24%

Total terpene lactones 6%

2, Ginkgo Biloba Extract 24/6

Total Ginkgo flavone glycosides 24%

Total terpene lactones 6%

Ginkgolic acid 5ppm

3,CP2005

Total Ginkgo flavone glycosides 24%

Quercatin: kaemperol 0.8–1.5

Total terpene lactones 6%

Ginkgolic acid <5ppm

4.Germany Standard

Total Ginkgo Flavone Glycosides 22.0%-27%

Total Terpene Lactones 5.0%-7.0%

Bilobalides 2.6%-3.2%

Ginkgolic acid <1ppm

5.Water-Soluble Ginkgo Biloba Extract 24/6

Water Solubility: 5g Ginkgo Biloba Extract will be dissolved completely in 100g water

Total Ginkgo Flavone Glycosides 24.0%

Total Terpene Lactones 6.0%

Ginkgolic acid <5.0ppm

[Appearance] Light yellow fine powder

[Particle size] 80 Mesh

[Loss on drying] £ 5.0%

[Heavy Metal] £10PPM

[Extract solvents] Ethanol

[Storage] Store in cool & dry area, keep away from the direct light and heat.

[Package] Packed in paper-drums and two plastic-bags inside.

[Function]

Expanding blood vessel, resisting insufficient blood and oxygen deficit, increasing blood flow, improving cerebral arteries and distal

blood flow. Promoting cerebral circulation metabolism, improving memory function, resisting depression, resisting lipidic overoxidation,

protecting liver damage.

In clinic, curing high blood pressure, hyperlipoidemia, coronary heart disease, angina pectoris, arterial sclerosis, cerebral embolism,

senile dementia, primary and periodic dropsy, acute drumming in the ears, epicophosis, a variety of body function in disorder, dizziness

and so on.

Rendering Beeswax – First Melt and Filter

This is Part 1. This takes the original combs straight from the hive down to a solid block for the first render. In this case, the combs had been slimed by small hive beetle (SHB) and contained all sorts of dead bee larva, beetle larva, wax moth, honey, etc. So just a whole hodgepodge of stuff.

Like usual, it is all melted together in one big pot with plenty of water. In general, the dirtier your wax, the higher your water/wax ratio needs to be . We melt it all down into a liquid mix, then sieve out the large solids, cocoons, larva, and dead bees.

Once it cools and solidifies, the wax has all floated to the top and leaves suspended gooey solids on the bottom, and also heavier solids that have sunk to the bottom of the pan.

Now we rinse off all the loose mucky debris. Next up we’ll take this same block of wax, and likely a few more like it after their primary render, and melt all of them together again. Hopefully if they all have a primary this clean, then all we’ll need is a secondary to pull out residual dirtiness, and isolate wax from propolis.

www.brueggensbees.com
facebook: brueggens bees

This video is about OPC-3 Video