Installation
Install the oil press on horizontal plane to ensure it is steady.
Preparation before running
Switch on and open the machine to observe it runs foreward or not, turn the wheel with hands to check it is locked or not, tighten the screw and turn inversely to make sure it is in normal condition, then run the oil press.
Oil extraction
Switch on and make sure the machine is in normal condition, then materials can be fed slowly. Start feeding with a low speed and flow the materials equably as water running. Observe the place which the oil cake comes out, charge substantial materials when oil cake gets out, the thickness of the cake should be 1-1.5mm.
Electrical control cabinet
Set the temperature to 110℃, it will automatically stop heating when temperature reaches 110℃. Indicator light “heating 1″ is for the host machine and “heating 2″ is for oil pan. Be sure to start venting first, then turn on the switch and discharge oil. Turn off vacuum pump after all oil filtered, and remove the remaining residue. Clean the oil filter or change filter cloth if it does not work normally (filter the oil) when the gas of vacuum pump reaches 0.01.